8-bit Microcontrollers (MCU) 8kB Flash 0.5kB EEPROM 23 I/O Pins
ATMEGA8L-8PU: 8-bit Microcontrollers (MCU) 8kB Flash 0.5kB EEPROM 23 I/O Pins
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Core : | AVR | Processor Series : | ATMEGA8x | ||
Data Bus Width : | 8 bit | Maximum Clock Frequency : | 8 MHz | ||
Program Memory Size : | 8 KB | Data RAM Size : | 1 KB | ||
On-Chip ADC : | Yes | Operating Supply Voltage : | 2.7 V to 5.5 V | ||
Package / Case : | PDIP-28 | Mounting Style : | Through Hole |
The AVR core of ATMEGA8L-8PU combines a rich instruction set with 32 general purpose working registers.All the 32 registers are directly connected to the Arithmetic Logic Unit (ALU), allowing two independent registers to be accessed in one single instruction executed in one clock cycle. The resulting architecture is more code efficient while achieving throughputs up to ten times faster than conventional CISC microcontrollers.
The ATMEGA8L-8PU provides the following features: 8K bytes of In-System Programmable Flash with Read-While-Write capabilities, 512 bytes of EEPROM, 1K byte of SRAM, 23 general purpose I/O lines, 32 general purpose working registers, three flexible Timer/Counters with compare modes, internal and external interrupts, a serial programmable USART, a byte oriented Two-wire Serial Interface, a 6-channel ADC (eight channels in TQFP and QFN/MLF packages) with 10-bit accuracy, a programmable Watchdog Timer with Internal Oscillator, an SPI serial port, and five software selectable power saving modes. The Idle mode stops the CPU while allowing the SRAM,Timer/Counters, SPI port, and interrupt system to continue functioning. The Powerdown mode saves the register contents but freezes the Oscillator, disabling all other chip functions until the next Interrupt or Hardware Reset. In Power-save mode, the asynchronous timer continues to run, allowing the user to maintain a timer base while the rest of the device is sleeping. The ADC Noise Reduction mode stops the CPU and all I/O modules except asynchronous timer and ADC, to minimize switching noise during ADC conversions. In Standby mode, the crystal/resonator Oscillator is running while the rest of the device is sleeping. This allows very fast start-up combined with low-power consumption.
The ATMEGA8L-8PU is manufactured using Atmel's high density non-volatile memory technology.The Flash Program memory can be reprogrammed In-System through an SPI serial interface, by a conventional non-volatile memory programmer, or by an On-chip boot program running on the AVR core. The boot program can use any interface to download the application program in the Application Flash memory. Software in the Boot Flash Section will continue to run while the Application Flash Section is updated, providing true Read-While-Write operation. By combining an 8-bit RISC CPU with In-System Self-Programmable Flash on a monolithic chip, the Atmel ATMEGA8L-8PU is a powerful microcontroller that provides a highly-flexible and cost-effective solution to many embedded control applications.The ATMEGA8L-8PU AVR is supported with a full suite of program and system development tools, including C compilers, macro assemblers, program debugger/simulators, In-Circuit Emulators, and evaluation kits.
Technical/Catalog Information | ATMEGA8L-8PU |
Vendor | Atmel |
Category | Integrated Circuits (ICs) |
Program Memory Size | 8K x 8 |
RAM Size | 1K x 8 |
Number of I /O | 23 |
Package / Case | 28-DIP |
Speed | 8MHz |
Controller Series | ATmega |
Oscillator Type | Internal |
Packaging | Tube |
Program Memory Type | FLASH |
EEPROM Size | 512 x 8 |
Core Processor | AVR |
Data Converters | A/D 6x10b |
Core Size | 8-Bit |
Operating Temperature | -40°C ~ 85°C |
Connectivity | I²C, SPI, UART/USART |
Peripherals | Brown-out Detect/Reset, POR, PWM, WDT |
Voltage - Supply (Vcc/Vdd) | 2.7 V ~ 5.5 V |
Drawing Number | * |
Lead Free Status | Lead Free |
RoHS Status | RoHS Compliant |
Other Names | ATMEGA8L 8PU ATMEGA8L8PU |