ASA2812D

The ASA28XXD Series of DC/DC converters are high reliability thick film hybrid converters that use flyback topology operating at a nominal frequency of 550Khz. High input to output isolation is achieved through the use of transformers in the flyback power and feedback circuits.

The advanced feedback design of ASA2812D provides fast loop response for superior line and load transient characteristics and offers greater reliability than devices incorporating optical feedback circuits.

ASA2812D is designed to meet MIL-STD-704 input requirements offering full performance over a 16 to 40 volt input range. Output Power of up to 5 watts is available for either balanced or unbalanced loads.

Connecting the inhibit pin (pin 5) to the input common (pin 7) will cause the converter to shut down. ASA2812D is recommended that the inhibit pin be driven by an open collector device capable of sinking at least 400A. The open circuit voltage of the inhibit pin is 11.5 ±0.5 volts. These converters ASA2812D are manufactured in a facility fully qualified to MIL-PRF-38534. All processes used to manufacture these converters have been qualified to enable Advanced Analog to deliver compliant devices. Three standard temperature grades of ASA2812D are offered with the screening options. Refer to Part Number section.

The CH grade converters of ASA2812D are fully compliant to MILPRF- 38534 for class H. The HB grade converters are processed with the same screening as the CH grade, but do not have class H element evaluation as required by MIL-PRF-38534. These two grades are fully tested and operate over the full military temperature range without derating of output power. A commercial grade of ASA2812D is also available. Variations of ASA2812D in electrical, mechanical and screening can be accommodated. Extensive computer simulation using complex modeling enables rapid design modification to be provided. Contact Advanced Analog with specific requirements.