PinoutDescriptionThe AAT4680IGV-T1 electronic resettable fuse is part of the anaalogicTech application specific power MOSFET line of products.It is 1A current limited P-channel MOSFET power device that remains fully enhanced as the input power supply is above an under voltage lockout threshold,and...
AAT4680IGV-T1: PinoutDescriptionThe AAT4680IGV-T1 electronic resettable fuse is part of the anaalogicTech application specific power MOSFET line of products.It is 1A current limited P-channel MOSFET power device t...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $.12 - .2 / Piece
Power Switch ICs - Power Distribution Slew Rate Controlled Load Switch
The AAT4680IGV-T1 electronic resettable fuse is part of the anaalogicTech application specific power MOSFET line of products.It is 1A current limited P-channel MOSFET power device that remains fully enhanced as the input power supply is above an under voltage lockout threshold,and the load is below the current limit setting.
Features of the AAT4680IGV-T1 are:(1)500mA steady state load current;(2)600mA minimum current limit trip point;(3)400m typical RDS(ON);(4)low quiescent current,typically 10 A;(5)fast transient response < 1s ressponse to short circuit;(6)over temperature protection;(7)FAULT flag with 3ms blanking;(8)under voltage lockout;(9)temperature range is -40 to 85;(10)5-pin SOT23 package.
The absolute maximum ratings of the AAT4680IGV-T1 can be summarized as:(1):the parameter IN to GND,the symbol is VIN,the value is -0.3 to 6,the unit is V;(2):the parameter OUT to GND,the symbol is VOUT,the value is -0.3 to 6,the unit is V;(3):the parameter FAULT to GND,the symbol is VFLG,the value is -0.3 to 6,the unit is V;(4):the parameter output current,the symbol is IOUT,the value is internally limited,the unit is A;(5):the parameter operating junction temperature range,the symbol is TJ,the value is -40 to 150,the unit is ;(6):the parameter maximum soldering temperature(at leads),the symbol is TLEAD,the value is 300,the unit is ;(7):the parameter ESD rating-HBM,the symbol is VESD,the value is 5000,the unit is V.