Features: Meets Bell and CCITT R1 specifications20-pin plastic DIPSingle low-tolerance 5V supplyDetects all 15 tone-pairs including ST and KPLong KP capabilityBuilt-in amplitude discriminationExcellent noise toleranceOutputs in either n of 6 or hexadecimal codeThree-state outputs, CMOS-compatibl...
78A207: Features: Meets Bell and CCITT R1 specifications20-pin plastic DIPSingle low-tolerance 5V supplyDetects all 15 tone-pairs including ST and KPLong KP capabilityBuilt-in amplitude discriminationExcell...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
PARAMETER | RATING |
DC Supply Voltage VDD | + 7V |
Operating Temperature | 0 to 70 (Ambient) |
Storage Temperature | 65 to 150 |
Power Dissipation (25) Derate above TA=25 @ 6.25 mW/ |
650mW |
Input Voltage | (VDD + 0.3V) to -0.3V |
DC Current into any input | ±10mA |
Lead Temperature (Soldering, 10 sec.) | 300 |
The 78A207 is a single-chip, Multi-Frequency (MF) receiver that can detect all 15 tone-pairs, including ST and KP framing tones. This receiver is intended
for use in equal access applications and thus meets both Bell and CCITT R1 central office register signaling specifications.
The 78A207 employs state-of-the-art switched capacitor filters in CMOS technology. The receiver consists of a bank of channel-separation bandpass filters followed by zero-crossing detectors and frequency-measurement bandpass filters, an amplitude check circuit, a timer and decoder circuit, and a clock generator. The device does not attempt to identify strings of digits by the KP (key pulse) and ST (stop) tone pairs.
No anti-alias filtering of the 78A207 is needed if the input signal is band-limited to 26KHz. The only external component required is an inexpensive television"color burst" 3.58 MHz crystal.
The outputs of the 78A207 interface directly with standard CMOS or TTL circuitry and are three-state enabled to facilitate bus-oriented architecture.