Features: • Gated serial data inputs• Typical shift frequency of 100MHz• Asynchronous Master Reset• Buffered clock and data inputs• Fully synchronous data transfer• Industrial temperature range available (40°C to +85°C)PinoutSpecifications(Operation beyond the l...
74F164: Features: • Gated serial data inputs• Typical shift frequency of 100MHz• Asynchronous Master Reset• Buffered clock and data inputs• Fully synchronous data transfer̶...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
(Operation beyond the limit set forth in this table may impair the useful life of the device. Unless otherwise noted these limits are over the operating free air temperature range.)
SYMBOL |
PARAMETER |
RATING |
UNIT | |
VCC |
Supply voltage |
0.5 to +7.0 |
V | |
VIN |
Input voltage |
0.5 to +7.0 |
V | |
IIN |
Input current |
30 to +5 |
mA | |
VOUT |
Voltage applied to output in High output state |
0.5 to VCC |
V | |
IOUT |
Current applied to output in Low output state |
40 |
mA | |
Tamb |
Operating free-air temperature range | Commercial Range |
0 to +70 |
°C |
Industrial Range |
40 to +85 | |||
Tstg |
Storage temperature range |
65 to +150 |
°C |
The 74F164 is an 8-bit edge-triggered shift register with serial data entry and an output from each of the eight stages. Data is entered through one of two inputs (Dsa, Dsb); either input can be used as an active High enable for data entry through the other input. Both inputs must be connected together or an unused input must be tied High.
Data shifts one place to the right on each Low-to-High transition of the clock (CP) input, and enters into Q0 the logical AND of the two data inputs (Dsa, Dsb) that existed one setup time before the rising edge. A Low level of the 74F164 on the Master Reset (MR) input overrides all other inputs and clears the register asynchronously, forcing all outputs Low.