5962-8957002KPC

Current Transfer Ratio :
Maximum Input Diode Current :
Packaging :
Minimum Operating Temperature : - 55 C
Maximum Reverse Diode Voltage : 3 V
Maximum Forward Diode Voltage : 1.85 V
Maximum Operating Temperature : + 125 C
Maximum Baud Rate : 40 MBps
Package / Case : PDIP-8
Maximum Power Dissipation : 200 mW


Description

The DSCC SMD 5962-8957002KPC is a highest reliability level Class K single channel hermetically sealed optocoupler in an 8-Pin ceramic DIP package with gold plated leads. Solder dipped leads and various lead form options are also available. See the datasheet for details.
The product is capable of operation and storage over the full military temperature range and may also be purchased as either commercial grade or with full MIL-PRF-38534 Class Level H testing on the same DSCC Standard Microcircuit Drawing. The 5962-8957002KPC is manufactured and tested on a MIL-PRF-38534 certified line and is included in the DSCC Qualified Manufacturers List QML-38534 for Hybrid Microcircuits.
The 5962-8957002KPC contains an AlGaAs light emitting diode which is optically coupled to an integrated high gain photon detector. This combination results in very high data rate capability. The detector 5962-8957002KPC has a threshold with hysteresis which typically provide 0.25 mA of differential mode noise immunity and minimizes the potential for output signal chatter. The detector 5962-8957002KPC in the single channel units has a three state output stage which eliminates the need for a pull-up resistor and allows for direct drive of a data bus.
5962-8957002KPC are compatible with TTL, STTL, LSTTL, and HCMOS logic families. The 35 ns pulse width distortion specification guarantees a 10 MBd signaling rate at 125 degrees C with 35% pulse width distortion.
Package styles for this die set in one or two channels are 8-Pin DIP through hole and 20 pad leadless ceramic chip carrier. Most 5962-8957002KPC may be purchased with a variety of lead forms and plating options. See the datasheet for details.
Because the same electrical die of 5962-8957002KPC (emitters and detectors) are used for each channel of each device listed in the datasheet, absolute maximum ratings, recommended operating conditions, electrical specifications, and performance characteristics shown in the datasheet figures are virtually identical for all parts. Occasional exceptions exist due to package variations and limitations and are as noted. Additionally, the same package assembly processes and materials are used in all devices. These similarities of 5962-8957002KPC give justification for the use of data obtained from one part to represent other parts performance for reliability and certain limited radiation test results.