43860

      The 43860 is Right Angle, Low Profile Inverted Shielded and Unshielded Versions with Low or High Temperature Lightpipes. 43860 has 7 feature and beneflts.The first one is plug latch on top.The second one is lightpipes molded in low- or high-temperature materials.The third one is lower electrical noise than LED offerings.The fourth one of the 43860 is 34% fewer leads than LED offerings.The fifth one is enhanced grounding tabs on shield.The sixth one is surface Mount Compatible for high temperature lightpipe version.The last one of the 43860 is shortened leads with bottom contacts.
      Molex Incorporated introduces a new inverted right angle modular jack with lightpipes that significantly reduces the noise created by the "antenna" effect of LED leads incorporated into the modular jack. The lightpipes direct the light emitted from the LEDs mounted on the PC board rather than using conventional LEDs mounted in the modular jacks. This design maintains signal integrity since there is no interference from LED leads. Because the LEDs are located on the PC board, you can select the colors used for the LEDs. Unlike typical LED modular jacks, you are not restricted to the standard green,yellow or orange LEDs. The combination of PC board mounted LEDs and lightpipes results in less noise being radiated though transmission lines.The inverted modular jacks with lightpipes are available in through hole styles for wave soldering or a high temperature version for reflow soldering. The high-temperature version maintains performance at a +260°C reflow soldering temperature for 1 minute without deforming the modular jack or lightpipe. Shielded and unshielded offerings are available for both RJ11 and RJ45 configurations for the standard through hole version and a shielded modular jack is offered with the high temperature lightpipes.