433201A

      The models 433201A and 433202A is Microprocessor Calibrator/Thermometer.In the 'Measurement' mode, a millivolt (mV) signal is accepted from a thermocouple and is displayed on the 4-digit LCD display. A built-in temperature offset of 433201A and 433202A feature can be used to compensate for variations found in standard thermocouples. By adjusting the offset,measurement accuracy for a particular thermocouple can be optimized for a particular temperature.In the 'Source' mode, a millivolt signal is output to an external device with the corresponding temperature (according to standard temperature tables) displayed on the LCD display. Preset temperature settings (source mode only) according to thermocouple type are stored in five memory locations for easy recall.If desired, the meter can be switched to the mV mode where Measurement and Source values can be displayed in millivolts rather than temperature.Careful use of this 433201A and 433202A will provide years of reliable service.
      The models 433201A and 433202A has 10 descriptions.
The first one is LCD display Temperature values can be displayed in oC/oF or in millivolts. The adjustable display can be easily moved to the best viewing angle.The second one is POWER/MODE button Press to power meter on/off and to select the desired mode of operation. With the meter powered on, momentarily press the POWER/MODE button (<2 sec) to toggle between MEASURE and SOURCE mode.In MEASURE mode the meter displays the temperature or mV value for an attached thermocouple or thermocouple simulator. In the SOURCE mode, the meter outputs a mV signal.To power off, press and hold the POWER/MODE button for more than 2 seconds.The third one of 433201A and 433202A is FINE/COARSE output adjustment buttons Use the / buttons to set the desired temperature. Press and hold for COARSE adjustment; momentarily press for FINE adjustment.The fourth one is oC/oF button Press to select the desired unit of measure.The fifth one is TYPE button Press to select a thermocouple type.The sixth one is MEM In SOURCE MODE, the Memory button provides access to five memory locations with preset output values depending on which thermocouple type is being used.The seventh one of 433201A and 433202A is Output/Input mini connector Thermocouples, thermocouple wire, and calibration cables are connected here.The eigthth one is AC adaptor/recharger jack.The ninth one is battery compartment Houses the supplied 9V Nickel Metal Hydride rechargeable battery. An alkaline battery can also be used.The last one of 433201A and 433202A is Neck Strap Posts- Attach the neck-strap to the two posts on the front corners of the meter.