Features: • 10 MHz max. clock frequency• Low-power CMOS technology- Max. Write Current: 5 mA at 5.5V, 10 MHz- Read Current: 5 mA at 5.5V, 10 MHz- Standby Current 1 A at 5.5V• 128 x 8-bit organization• Write Page mode (up to 16 bytes)• Sequential Read• Self-timed...
25LC010A: Features: • 10 MHz max. clock frequency• Low-power CMOS technology- Max. Write Current: 5 mA at 5.5V, 10 MHz- Read Current: 5 mA at 5.5V, 10 MHz- Standby Current 1 A at 5.5V• 128 x...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
Absolute Maximum Ratings(†)
VCC................................................................................................6.5V
All inputs and outputs w.r.t. VSS ........................... -0.6V to VCC +1.0V
Storage temperature ................................................-65°C to 150°C
Ambient temperature under bias...............................-40°C to 125°C
ESD protection on all pins..............................................................4 kV
† NOTICE: Stresses above those listed under "Absolute Maximum Ratings" may cause permanent damage to the
device. This is a stress rating only and functional operation of the device at those or any other conditions above those
indicated in the operational listings of this specification is not implied. Exposure to maximum rating conditions for an
extended period of time may affect device reliability.
Parameter Name | Value |
Density | 1 Kbit (x8) |
Max. Clock Freq. | 10 MHz |
Page Size (bytes) | 16 |
Write Protect | Quarter, Half, Whole Array |
Endurance | 1,000,000 |
Op. Volt Range (V) | 2.5 to 5.5 |
Temp Range (°C) | -40°C to +125°C |
The Microchip Technology Inc. 25XX010A* is a 1k-bit Serial Electrically Erasable Programmable Read-Only Memory (EEPROM). The memory is accessed via a simple Serial Peripheral Interface™ (SPI™) compatible serial bus. The bus signals required are a clock input (SCK) plus separate data in (SI) and data out (SO) lines. Access to the device is controlled through a Chip Select (CS) input.
Communication to 25XX010A* can be paused via the hold pin (HOLD). While the device is paused, transitions on its inputs will be ignored, with the exception of Chip Select, allowing the host to service higher priority interrupts.
The 25XX010A* is available in standard packages including 8-lead PDIP and SOIC, and advancedpackages including 8-lead MSOP and 8-lead TSSOP. Pb-free (Pure Matte Sn) finish is also available.