Features: Up to 500 mA Continuous Load Current per Port140 mΩ Maximum ON-Resistance1.25 A Maximum Short-Circuit Current LimitIndividual Open-Drain Fault Flag Outputs125 µA Typical ON-State Supply Current<1 µA Typical OFF-State Supply CurrentOutputs Can be Forced Higher Than In...
2526: Features: Up to 500 mA Continuous Load Current per Port140 mΩ Maximum ON-Resistance1.25 A Maximum Short-Circuit Current LimitIndividual Open-Drain Fault Flag Outputs125 µA Typical ON-Sta...
SeekIC Buyer Protection PLUS - newly updated for 2013!
268 Transactions
All payment methods are secure and covered by SeekIC Buyer Protection PLUS.
US $.26 - .26 / Piece
Circuit Board Hardware - PCB SWAGE MNT SOLDER TERMINALS
US $.27 - .27 / Piece
Circuit Board Hardware - PCB 200u SN/PB OVER NI
The A2526EL/M and A2536EL/M are integrated high-side dual power switches, optimized for self-powered and bus-powered Univer- sal Serial Bus (USB) applications. Few external components are necessary to satisfy USB requirements. TheA2526EL/M and A2536EL/M ENABLE inputs are active high; the A2536EL/EM are active low.
A2526EL/M and A2536EL/M are ideally suited for USB applications. Each switch channel supplies up to 500 mA as required by USB peripheral devices. In addition, the switch's low on-resistance permits achieving the USB voltage-drop requirements. Fault current is limited to typically 750 mA, satisfying the UL 25 VA safety requirements, and a flag output is available to indicate a fault condition to the local USB controller. Momentary voltage drops that may occur on the upstream port when the switch is enabled in bus-powered applications is elimi- nated by a "soft start" feature.