2100

The specifications of 2100 and 2100T(Photoelectronic Smoke Detectors) are Diameter: 5.5 inches (140 mm); Height (including mounting bracket): 1.7 inches (43 mm); Weight: 5.3 oz. (150 g); Operating Temperature Range: Model 2100: 32° to 120°F (0° to 50° C), Model 2100T:  32° to 100°F (0° to 39°C); Operating Humidity Range: 10% to 93% Relative Humidity, Noncondensing; Latching Alarm: Reset by momentary power interruption; Heat Sensor (Model 2100T only): 135°F Fixed Temperature Electronic Thermistor.

The 2100 Electrical Ratings are System Voltage Nominal: 12 or 24 VDC/Minimum: 8.5 VDC/Maximum: 35 VDC, Maximum Ripple Voltage: 30% of nom. Voltage (peak to peak), Start-up Capacitance: 0.02 µF maximum, Standby Current: 50 µA maximum, Alarm Ratings: 4.2 VDC minimum at 10 mA./6.6 VDC maximum at 100 mA.(Alarm current must be limited to 100 mA maximum by the control panel. If used, the RA400Z Remote Annunciator operates within the specified detector alarm currents.); Reset Voltage: 2.5 VDC minimum; Reset Time: 0.3 seconds maximum; Start-up Time: 30 seconds maximum (after 60 second reset).

Model 2100 is a 2-wire photoelectronic smoke detector that uses a state-of-the-art optical sensing chamber. This detector is designed to provide open area protection and to be used with compatible UL-listed panels only. Model 2100T features  a  restorable,  built-in,  fixed-temperature  (135° F) thermal detector.Installation of these detectors is simplified by the use of a mounting bracket and a plug-in screw terminal block that can be prewired to the system, allowing the detector to be easily installed or removed for cleaning. The detector's sensitivity  can  be  tested  in  place  using  the  MOD400R  Test Module. An LED on the detector provides a local visual indication of the detector's status. If power is applied to the detector, and it is functioning normally in standby, the status LED blinks every ten seconds. The LED also latches on in alarm.

Models  2100  and  2100T  feature  a  visual  indication  that maintenance is required if the sensing chamber drifts out of its sensitivity limits, the LED ceases to blink. The  detectors  also  include  an  output  that  allows  an  optional Model RA400Z Remote Annunciator to be connected.

Before Installing(Please  thoroughly  read  System  Sensor  manual  I56-407, Guide for Proper Use of System Smoke Detectors, which provides detailed information on detector spacing, placement, zoning,  wiring,  and  special  applications.  Copies  of  this manual are available at no charge from System Sensor.); NOTICE(This manual should be left with the owner/user of this equipment.); IMPORTANT(This detector must be tested and maintainedregularly  following  NFPA  72  requirements. The detector should be cleaned at least once a year.)

Each 2100 and 2100T detector is supplied with a mounting bracket that permits the detector to be mounted:1. To a single gang box, or 2. Directly to a 3-1/2 inch or 4 inch octagonal box, or 3. To a 4 inch square electrical box by using a plaster ring.