1893AFI

Specifications

Package SSOP 48 Speed NA Temperature I Voltage 3.3 V


Description

3.3V 10BASE-T/100BAS
The 1893AFI is a lower cost, re-packaged version of the ICS1893Y-10. The 1893AFI is a fully integrated, Physical Layer device (PHY) that is compliant with both the 10Base-T and 100Base-TX CSMA/CD Ethernet Standard, ISO/IEC 8802-3. The 1893AFI uses the same proven silicon as the ICS1893Y-10 but offers a lower cost solution by using a lower cost 300 mil. 48-lead SSOP package.

The ICS1893AF uses the same twisted-pair transmit and receive circuits as the ICS1893Y-10, and the same recommended board layout techniques apply to the ICS1893AF.

The 1893AFI is intended for Node applications using the standard MII interface to the MAC.

Single 3.3V power supply

Supports category 5 cables with attenuation in excess of 24dB at 100 MHz.

DSP-based baseline wander correction to virtually eliminate killer packets

Low-power, 0.35-micron CMOS (typically 400 mW)

Single-chip, fully integrated PHY provides PCS, PMA, PMD, and AUTONEG sublayers of IEEE standard

10Base-T and 100Base-TX IEEE 802.3 compliant

Clock or crystal supported

Media Independent Interface (MII) supported

Managed or Unmanaged Applications

10M or 100M Half and Full Duplex Modes

Auto-Negotiation with Parallel detection for Legacy products

Fully integrated, DSP-based PMD includes: Adaptive equalization and baseline wander correction Transmit wave shaping and stream cipher scrambler MLT-3 encoder and NRZ/NRZI encoder

Loopback mode for Diagnostic Functions

Small footprint 48-pin 300 mil SSOP package.

Available in Industrial Temperature and Lead Free packaging.