0805LS-102XJLC

The 0805LS-102XJLC is a kind of chip inductors. They come in inductance values from 0.078 to 27 H. These ferrite core surface mount inductors have lower DCR and higher current ratings than our 0805CS Series. Coilcraft Designer's Kit C354 contains samples of all 5% inductance tolerance parts. To order, contact Coilcraft or visit http://order.coilcraft.com to purchase on-line.

The features of 0805LS-102XJLC can be summarized as (1)core material ceramic/ferrite; (2)terminations rohs compliant silver-palladium-platinum-glass frit. Other terminations available at additional cost.; (3)weight: 12.7 13.9 mg; (4)ambient temperature 40°C to +85°C with Irms current, +85°C to +100°C with derated current; (5)storage temperature component: 40°C to +100°C. packaging: 40°C to +80°C; (6)resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles; (7)temperature coefficient of inductance (TCL) +100 to +250 ppm/°C; (8)moisture sensitivity level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity); (9)failures in time (FIT) / mean time between failures (MTBF) one per billion hours / one billion hours, calculated per Telcordia SR-332; (10)packaging 2000 per 7reel; 7500 per 13 reel; plastic tape: 8 mm wide, 0.23 mm thick, 4 mm pocket spacing, 1.6 mm pocket depth; (11)PCB washing only pure water or alcohol recommended.

The absolute maximum ratings of 0805LS-102XJLC are 1. when ordering, specify tolerance, termination and packaging codes. 2. inductance measured using a Coilcraft SMD-A fixture in an Agilent/ HP 4286A impedance analyzer with Coilcraft-provided correlation pieces. 3. Q measured on an Agilent/HP 4291A with an Agilent/HP 16193 test fixture. 4. SRF measured using an Agilent/HP 8753D network analyzer with a Coilcraft SMD-D test fixture. 5. DCR measured on a Cambridge Technology Micro-ohmmeter. 6. Current that causes a 15°C temperature rise from 25°C ambient. Because of their open construction, these parts will not saturate. 7. Electrical specifications at 25°C. Refer to Doc 362 "Soldering Surface Mount Components" before soldering.