Battery_operated_fluorescent_light_for_one_or_two_8_watt_units

Published:2009/7/17 4:54:00 Author:Jessie | From:SeekIC

Battery operated fluorescent light for one or two 8-watt units. The circuit is a simple transistor inverter operated by a 12-volt battery. T1 is 200 turns of AWG #32 magnet wire in two layers of 100 turns each. Cover the first layer with electrical tape before starting the second. Then cover the second with tape. Mark the two ends as start (S) and finish (F); mark this winding as N1. Next wind N2 as six turns of AWG #32 magnet wire over N1 in the same direction. Mark each end of N2 with start (S) and finish (F). Then wind N3 as eight turns of AWG #20 magnet wire over N2 in the same direction. Mark N3 with S and F leads. Each layer should have electrical tape over it (courtesy General Electric Company).



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Power_Supply_Circuit/Battery_operated_fluorescent_light_for_one_or_two_8_watt_units.html

Print this Page | Comments | Reading(3)