Published:2009/6/24 5:33:00 Author:Jessie | From:SeekIC
A 4-V signal will cause the relay to pull in when Q1 turns on. Latching is obtained by feedback through a 4.7-kΩ resistor. A switch is used to select latching or nonlatching operation. A NO pushbutton releases the circuit.
Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Control_Circuit/Relay_Control/LATCHING_RELAY_DRIVER_FOR+12_V_LOADS.html
Print this Page | Comments | Reading(3)
Code: