MAGNETRON_BEAM_SWITCHING

Published:2009/7/16 22:49:00 Author:Jessie | From:SeekIC

First trigger pulse switches beam to first position, and each succeeding trigger advances beam one position, until reset pulse zeroes V11 for repetition of switching sequence. Succeeding switching-circuit output pulses are thus time-coincident with succeeding amplitude portions of input signal, for pulse amplitude measurement.-J. F. Lyons, Jr., Analyzing Multipath Delay in Communications Studies, Electronics, 32:36, p 52-55.



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Control_Circuit/MAGNETRON_BEAM_SWITCHING.html

Print this Page | Comments | Reading(3)