LOW_OUTPUT_IMPEDANCE_MULTIPLEXER

Published:2009/6/24 3:08:00 Author:Jessie | From:SeekIC

Both inputs are terminated in their characteristic impedance; 75Ω is typical for video applications. Because the output cables usually are terminated in their characteristic impedance, the gain is 0.5. Consequently, amplifiers U2A and U2B are configured in a gain of +2 to set the circuit gain at 1.R2 and R3 determine the amplifier gain; if a different gain is desired, R2 should be changed according to the equation G = (1 + R3/R2) R5, LCL1, and D1 make up an asymmetrical charge/discharge time circuit that configures U1 as a break-before-make switch to prevent both amplifiers from being ac-tive simultaneously. The multiplexer transition time is approximately 15μs with the component values shown.



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Control_Circuit/LOW_OUTPUT_IMPEDANCE_MULTIPLEXER.html

Print this Page | Comments | Reading(3)