Published:2009/7/3 3:07:00 Author:May | From:SeekIC
The generator output is rectified then filtered and applied between the positive supply voltage and the base of the detector transistor. This provides a negative voltage which reduces the base-voltage when the speed increases. In normal operation, if the tachometer voltage is less than desired, the detector transistor is turned on, then turns on Q2 which causes the timing capacitor for the unijunction transistor to charge quickly. As the tachometer output approaches the voltage desired, the base-emitter voltage is reduced to the point at which Q1 is almost cut off. Thereby, the collector current which charges the unijunction timing capacitor is reduced, causing that capacitor to charge slowly and trigger the thyristor later in the half cycle. In this manner, the average power to the motor is reduced until just enough power to maintain the desired motor speed is allowed to flow.
Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Control_Circuit/CONSTANT_SPEED_MOTOR_CONTROL_USING_TACHOMETER_FEEDBACK_.html
Print this Page | Comments | Reading(3)
Code: