AUTOMATIC_HEADLIGHT_DIMMER

Published:2009/7/3 3:47:00 Author:May | From:SeekIC

This circuit switches car headlights to the low beam state when it senses the lights of an on-coming car. The received light is very low level and highly directional, indicating the use of a lens with the detector. A relatively large amount of hysteresis is built into the circuit to prevent flashing lights. Sensitivity is set by the 22 megohm resistor to about 0.5 ft. candle at the transistor (0.01 at the lens), while hysteresis is determined by the R1, R2 resistor voltage divider, parallel to the D41K3 collector emitter, which drives the 22 megohm resistor; maximum switching rate is limited by the 0.t μF capaci-tor to 15/minute.



Reprinted Url Of This Article:
http://www.seekic.com/circuit_diagram/Control_Circuit/AUTOMATIC_HEADLIGHT_DIMMER.html

Print this Page | Comments | Reading(3)